Hayward Phantom Swimming Pool Cleaner Large Capacity Debris Bag Part AX6000BA

Description

Hayward Phantom Swimming Pool Cleaner Large Capacity Debris Bag Part AX6000BA
Cleaner bag is designed for use with the Hayward Phantom Pool cleaner shown in photo below.
Part is Brand New in Hayward factory sealed bag.
AX6000BA
Attaching Debris Bag
1. Place the frame of the Debris Bag against the back
of the Cleaner as shown.
2. Press down on the top corners of the frame.
3. Press down on the top-center of the frame to lock
the Debris Bag in place.
Removing Debris Bag
1. Pull the top of the Debris Bag frame back and then up.
Note: If you allow the bag to dry, the debris will be easier to remove.
Emptying Debris Bag
1. Hold Bag over trash can or wherever debris is to be placed.
2. Slide Float Closure off of bag.
3. Hold open edges apart and shake debris from bag.
4. Slide Float Closure onto bag.
Sand (dense debris)
If too much sand or heavy debris is collected in the Debris Bag,
the bag will “droop” over the hose while on the bottom and the
Cleaner may not be able to ascend to the surface properly. If you
observe the bag drooping over the hose turn the booster pump off
and empty the Debris Bag.
Note:
Pools with excessive amounts of sand should be manually
vacuumed before installing the Phantom Turbo.
Fine Debris
The Large Capacity Debris Bag, as with other pressure-side
cleaners, does not hold very fine sand or other powder-like
debris. Powder will be blown through the bag and into
suspension so it can be filtered by the pool’s filtration system.