Polaris Vac-Sweep 380 / 280 / 180 / 280 TankTrax Pressure Cleaner Back-up Valve

Description

Polaris Vac-Sweep 380 / 280 / 180 / 280 TankTrax Pressure Cleaner Back-up Valve Kit (G52)
The back-up valve kit is a replacement part made by Polaris. The same high-quality materials were used to manufacture the original factory part. Making this a genuine OEM product.
This back-up valve was designed to be the feature that backs the pressure side cleaner out of any corners or edges on the pool steps which would cause the cleaner to be hung up or impeded. Without it, the cleaner would be insufficient in its abilities to suck and pull up dirt and debris off your pool's surface.
This part is white and should be located approximately 18 inches from the head of the cleaner. It will turn on every 2 ½ to 3 minutes to pull the cleaner out of tight corners or trouble spots. One great troubleshooting tip if the cleaner is tangled up or floating at the top of the pool water would be to check this back-up valve. You can do this by pulling it out of the water to see if its running, it should run for approximately 30 seconds. If it runs longer than this then it means the internal has failed and is stuck in the open position and needs to be replaced. Just make sure you are purchasing the full assembly with the mechanism included. Replacing just the will not correct this issue.